Adding the 3M
™
PPS
™
Series 2.0
Spray Cup System Components
3M™ Performance Spray Gun HVLP – Gravity
Maximum Operating Pressure: 20 psi | 1.38 bar
Attach the supplied air flow valve to the bottom of the gun.
1
Insert the 3M™ PPS™ Series 2.0 Spray Cup System disposable
liner into the 3M™ PPS™ Series 2.0 Spray Cup System mixing cup.
1
2
Attach the nozzle to the spray gun with the locking collar fully
connected.
Note: It is easier to install the nozzle while pulling
the trigger backward toward the spray gun handle.
To remove
the nozzle from the spray gun, reverse the process.
2
Pour material to be sprayed into the 3M™ PPS™ Series 2.0
Spray Cup System mixing cup. Stir as needed.
4
Once the spray gun is properly assembled you may attach the
air line.
4
Turn until tight. Insert 3M™ PPS™ Series 2.0 Spray Cup Sys-
tem sealing plug prior to shaking or sealing.
5
Attach spray gun to filled 3M™ PPS™ Series 2.0 Spray Cup
System cup.
3
Attach 3M™ PPS™ Series 2.0 spray cup to nozzle.
3
Place the 3M™ PPS™ Series 2.0 Spray Cup System lid with
built-in filter on top of the 3M™ PPS™ mixing cup with liner
and snap into place.
2.0 1.8 1.6 1.4 1.3 1.2
Direct Gloss
Single Stage Top Coat
Wet on Wet Primer
High Viscosity Coatings
Sprayable Fillers
Primer Surfacer
Solvent Base Color
Primer Sealer
High Build Primer
Clearcoat
Waterborne Base Coat
VOLTAIRE 19
WARNING!
Do not immerse spray gun or nozzles in cleaning solvents or gun washers. The maximum operational air pressure of this
HVLP spray gun is 20 PSI.
Assembly
Nozzle Recommendation
*Starting points only, refer to Paint Manufacture for
recommendation on fluid tip size
VOLTAIRE 6
VOLTAIRE 5
VOLTAIRE 14
VOLTAIRE 13
Recommended Set Up Starting Points
Fan Control Knob: Open 2 rotations from closed position
Fluid Control Knob: Open 4 rotations from closed position
Air Flow control valve: 18-20 psi / 1.24 – 1.37 Bar
