38
EN
M1.2.CUT80HFI.NLFREN 09102018
4 Operation
4�1 Panel functions
No. Part name
Function
1
Digital meter
To display the cutting current
2
Rocket switch
For gas-check/cutting status conversion
3
Rocket switch
For 2T/4T cutting mode conversion
4
“+” output
terminal
To connect the earth clamp
5
Power indicator To indicate the machine is powered on when it
illuminates
6
Overheating
indicator
To indicate the temperature inside the
machine is too high and the machine is
under overheating protection status when it
illuminates.
7
Current control
knob
To adjust the output current value
8
“-” output
terminal
To connect the cutting torch
No. Part name
Function
1
Air reducer
valve
To adjust the pressure of the input air
2
Power switch
To control the ON/OFF of the input power to
the machine
3
Cable
For power supply input
Front panel
Back panel
10
3.2 Panel functions of L204/L205
Power switch To control the ON OFF of the input
power of the machine.
/
1
2
3
No. Part name
Function
Figure 3-3: Front panel of L204/L205
Figure 3-4: Back panel of L204/L205
1
2
3
4
No. Part name
Function
Current
control knob
To adjust the output current value.
To connect the cutting torch
5
6
7
8
Digital meter
To display the cutting current.
Rocket switch
For gas-check/cutting status conversion.
For 2T/4T cutting mode conversion.
Rocket switch
“+”
output
terminal
To connect the earth clamp.
Overheating
indicator
To indicate the temperature inside the
machine is too high and the machine
is under overheating protection status
when it illuminates.
Air reducer
valve
To adjust the pressure of the input
air.
Cable
For power supply input.
“-”
output
terminal
1
6 0
Power
indicator
To indicate the machine is powered on
when it illuminates.
10
3.2 Panel functions of L204/L205
Power switch To control the ON OFF of the input
power of the machine.
/
1
2
3
No. Part name
Function
Figure 3-3: Front panel of L204/L205
Figure 3-4: Back panel of L204/L205
1
2
3
4
No. Part name
Function
Current
control knob
To adjust the output current value.
To connect the cutting torch
5
6
7
8
Digital meter
To display the cutting current.
Rocket switch
For gas-check/cutting status conversion.
For 2T/4T cutting mode conversion.
Rocket switch
“+”
output
terminal
To connect the earth clamp.
Overheating
indicator
To indicate the temperature inside the
machine is too high and the machine
is under overheating protection status
when it illuminates.
Air reducer
valve
To adjust the pressure of the input
air.
Cable
For power supply input.
“-”
output
terminal
1
6 0
Power
indicator
To indicate the machine is powered on
when it illuminates.
copyrighted
document
- all
rights
reserved
by
FBC
