27
vwr.com I Instruction manual VWR® G Water System
barb connector from the package. Twist the barb connector to the knob, then remove the yellow
tape from the O-ring. Make sure that the O-ring is firmly in place.
Step 2 Screw the assembled faucet onto the tank until it’s finger-tight.
c)
Screw the quick connector into the tank water inlet. Insert the two 8 mm elbow plugs provided
into the tank water inlet and outlet respectively.
Take out the 8 mm tubing from the system
accessories bag, cut two pieces in proper length of tubing to connect the tank to the system.
d)
Insert one end of the first 8 mm tubing into the
INLET
port at the top of the PE tank and the
other end into the
Product To Tank
of the system.
e)
Insert one end of the second 8 mm tubing into the
OUTLET
at the base of the PE tank and
the other end into the
Pure Water In
of the system.
f)
Screw the Tank Vent Filter to the top of the PE tank (see picture Tank Top View)
g)
Connect the cable plug from the tank level sensor to the
Level Sensor
port on the back of
the water system
h)
Connect the cable plug from the overflow sensor to the Overflow Sensor port on the back of
the water system.
Note
: If UV sanitization module is installed, skip step
h
.
Cable plug connects to the
Level Sensor port at the back of
the system
Cable plug connects the
Overflow Sensor port at the
back of the system
