Chapter 1: Product Summary
1.3 Product Introduction
(1) Tool carriage .................Part to drive the cutter/pen
(2
)
Y Bar...............................Holds the tool carriage; moves left/right
(3) Writing panel................
.
..Cutting/Plotting/Creasing work is performed on the panel.
(4) Storage box....................Placing tools such as knives, holders, pen holders, etc.
(5) Control panel..................Used to access various cutting plotter functions.
(6) Emergency stop switch...In an emergency, the power can be cut quickly.
(7) AC line inlet.....................Inlet where the power cable is connected.
(8) Power switch...................Used to turn the cutting plotter on and off.
(9) Network (LAN) interface connector
...................The connector used when connecting this cutting plotter with the network
(LAN)interface cable.
(10) U Disk port ..................The port that is used only for the USB memory.
(11) USB interface connector
..................Used to connect the cutting plotter to the computer with a USB interface cable.
(12)Air pump port.................Port that connects the air pump to the machine.
(13) Stand............................Stand for supporting the machine.
(14) Silencer.........................Reduce the noise of the air pump.
(15) Air pump....................... Adsorption. Fix the material on the platform.
(16) Regulation module........Adjust the strength of the wind and the internal pressure of the pump.
(17) Universal wheel............Move or fix the machine position.
1
2
3
4
5
6
13
17
7
8
9
10
11
12
15
16
14
Page 8
