LCD Display
Cause
Solution
Chapter 4: Troubleshooting and Maintenance
4.1 The error information of cutter
Page 32
Please adjust the
starting position!(X)
Please adjust the
starting position!(Y)
Loading...
Image does not fit the
machine size!
Cutter is busy!
There is not enough space in the X
direction when working on the ARMS
There is not enough space in the Y
direction when working on the ARMS
Change the material position
and reset the starting point.
Change the material position
and reset the starting point.
File loading
Interface loading
The cutter is working and cannot
perform other operations
Perform other operations,
after the work is completed,
Drawing...
The cutter is drawing a calibration file.
Oversize!
Working width exceeds the actual working
width of the machine
Modify the working size, please
pay attention to the actual
working size of the cutter.
Unsuccessful!
Calibration offset job failed
Confirm that the pen holder can
write normally,
and force of both tools are set
to 60g.
Read file error!
X Motor Error!
Motor Error!
Y Motor Error!
Read file error when work via U disk!
Rest cutter.
1:Check whether the motor is
affected by other resistance
during operation.
2:Check the motor circuit
connection.
3:Replace with new motor.
Please try to insert the U disk
into the cutter again
When using the RESET function,
the remaining working size of the cutter is
smaller than the size of the document to
be cut.
Change the material position
and reset the starting point.
