ER SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
F35613 (September 2003)
Page 8 of 48
REMOVAL AND REPLACEMENT OF PARTS
COVERS AND PANELS
WARNING:
DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT
/ TAGOUT PROCEDURES. THERE
MAY BE MULTIPLE CIRCUITS. BE
SURE ALL CIRCUITS ARE
DISCONNECTED.
Control Panel
1.
Remove screws at top of control panel and
lower panel.
2.
Disconnect wiring harness then remove control
panel.
3.
Reverse procedure to install.
Element Head Cover
1.
Remove basket hanger or lift arm(s) if basket
lift option is installed.
2.
Remove screws from rear of element head
assembly.
3.
Raise heating elements and place 2x4 lumber
under them for support.
4.
Remove screws from the bottom of element
head assembly.
5.
Grasp heating elements and remove 2x4
lumber. Lift the elements and pull toward rear
of fryer. Head cover will separate from element
head base.
A.
Lower the heating elements and place
them in fry tank.
NOTE
: Heating elements remain attached to
element head cover.
6.
Reverse procedure to install.
Basket Lift Covers
NOTE:
Applies to fryers with basket lift option only.
1.
Access rear of fryer.
2.
Remove basket lift arms from lift tubes.
3.
Remove screws securing upper cover to fryer.
Summary of Contents for ERC50
