Vortice VORT PRESS 110 I LL, Instruction Booklet

Page: 9 / 44

9
• Do not use this appliance for purposes other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt, contact a professionally qualified electrician
or Vortice*. Do not leave packaging within the
reach of children or infirm persons.
• Certain basic rules must be observed when using
electrical appliances: a) Never touch electrical
appliances with wet or damp hands; b) Never touch
electrical appliances while barefoot; c) Never allow
children or infirm persons to operate appliances
unattended.
• Store the appliance out of reach of children and
infirm persons after disconnecting it from the power
supply.
• Do not operate the appliance where inflammable
vapours or substances are present (alcohol,
insecticides, petrol, etc.)
• Take all necessary precautions to ensure that there
are no back flows of gas into the room from open-
flued combustion appliances.
• If the product is installed at a height less than 2.3
metres, fit a protection grille over the air outlet to
prevent access to the fan impeller (fig. B).
• Do not allow young children or infirm persons to
use the appliance without supervision.
• Supervise young children to ensure that they do
not play with the appliance.
• Do not make modifications of any kind to the appliance.
• Do not expose the appliance to the weather (rain,
sun, etc.).
• Periodically inspect the appliance for damage. If any
faults are found, do not operate the appliance;
contact Vortice* immediately.
• In the event that the appliance malfunctions or
develops a fault, contact Vortice* immediately.
Ensure that only genuine original Vortice spares are
used for repairs.
• In the event that the appliance is dropped or suffers a
heavy blow, have it checked immediately by Vortice*.
• The appliance must be installed by a professionally
qualified electrician only.
• Ensure that the electrical system to which the
appliance is connected complies with applicable
standards.
• The appliance is double insulated and therefore
does not need to be earthed.
• Check that the electrical power supply/socket provides
the maximum electrical power required by the
appliance. If this is not the case, arrange for a qualified
electrician to make the necessary modifications.
• Use a multi-polar switch with minimum contact gaps
of 3 mm to install the appliance.
• The timer should be adjusted by qualified personnel
only.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
cleaning the outside of the appliance, c) if the
appliance is not to be used for any length of time.
• Ensure that the room has an adequate source of fresh
air to ensure correct appliance operation. In the event
that other non-sealed combustion-based appliances
(such as water heater or gas stove) are installed in the
same room, check that air replacement is sufficient for
all appliances to work effectively together.
• Do not use the appliance to control activation of
water heaters, room heaters, etc., nor should it
discharge into the hot air flues of such appliances.
• Ensure that the appliance discharges into a single duct
(dedicated to this product) or directly to the outside.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, explosive or flammable mixtures).
• Keep the appliance intake and outlet grilles free to
ensure optimum air flow at all times.
• Install the appliance in such a way that the impeller
is inaccessible from the air delivery side, as verified
by contact with the Finger gauge (Fig. B), in
compliance with statutory accident prevention
regulations. If necessary, fit the fixed protective grille.
VORT PRESS IT LL
• “Intelligent” timer: when the light is on, the product
will start to work after approximately 40”; when the
light is off, the product will continue to work at
minimum speed for between 30” to 30’ (adjustable -
see fig. 22 and following).
• The appliance with timer operates at maximum
speed when the light is on, at minimum speed when
the light is off (fig. 13). A speed controller switch
(fig. 14) can also be fitted. When the light is on and
switch B is operated, the appliance will operate at
minimum or maximum speed; when the light is off,
the fan operates at minimum speed only.
Warning:
this symbol indicates precautions that must be taken to avoid injury
!
WARNING - CAUTION ENGLISH
Caution:
this symbol indicates precautions that must be taken to avoid damaging the appliance.
!
*or an authorized Vortice dealer if you are outside the UK-Ireland territory
.
• Install the appliance in such a way that the impeller
is inaccessible from the air delivery side, as verified
by contact with the Finger gauge, in compliance
with statutory accident prevention regulations.
If necessary, fit the fixed protective grille.
492 imp parziale:imp492.qxd 26/03/08 12.54 Pagina 9