Vortice ME 100/4" LL, Instruction Booklet

Page: 42 / 92

42
NB: when the supply voltage is applied the appliance starts up in “Test Mode” for a time of approximately 1 min 30 sec.
In the first 30 seconds of operation in "Test Mode" the signal supplied by the PIR module is ignored and the motor runs
at the speed set with the jumper. In the remaining 60 seconds the motor will only start after a signal from the PIR module,
at the speed set with the jumper; when there is no signal from the PIR module, the motor will stop immediately (time lag
for switching off = 0). At the end of the "Test Mode" phase, the appliance will go into normal operation.
Table B
Wiring diagrams
Fig. 21 ÷ 24
When using the wiring diagram in Figure 22 b, the humidity control cannot be disabled (models ME 100/4” LL TP HCS,
ME 120/5” LL TP HCS); you need to set the "Timer" operating mode (switch 6 = OFF in "DIP-switch" Table).
Maintenance and cleaning
Fig. 25 ÷ 27
Important information concerning the environmentally compatible disposal
IN CERTAIN EUROPEAN UNION COUNTRIES THIS PRODUCT DOES NOT FALL WITHIN THE REQUIREMENTS
OF THE NATIONAL LAWS IMPLEMENTING DIRECTIVE WEEE, AND IN THESE COUNTRIES THE PRODUCT IS
NOT SUBJECT TO SEPARATE DISPOSAL OPERATIONS AT THE END OF ITS WORKING LIFE.
This product conforms to EU Directive2012/19/EC.
This appliance bears the symbol of the barred waste bin. This indicates that, at the end of its useful life, it
must not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical
and electronic equipment, or returned to a retailer on purchase of a replacement.
It is the user's responsibility to dispose of this appliance through the appropriate channels at the end of its
useful life. Failure to do so may incur the penalties established by laws governing waste disposal.
Proper differential collection, and the subsequent recycling, processing and environmentally compatible disposal of
waste equipment avoids unnecessary damage to the environment and possible related healthrisks, and also promotes
recycling of the materials used in the appliance.
For further information on waste collection and disposal, contact your local waste disposal service, or the shop from
which you purchased the appliance.
Manufacturers and importers fulfil their responsibilities for recycling, processing and environmentally compatible disposal
either directly or by participating in collective systems.
ENGLISH
Speed Jumper
Position A Position B
V1 MIN speed MAX speed