Volvo V90 2019, Owner'S Manual

Page: 473 / 674

STARTING AND DRIVING
* Option/accessory. 471
4. Locate programming button
32
on the
receiver for the garage door or similar. It is
normally located close to the antenna's
bracket on the receiver.
5. Depress and release the receiver's program-
ming button once. The programming must be
completed within 30 seconds of the button
being depressed.
6. Press and release the button on HomeLink
®
that you want to program. Repeat the
sequence of pressing/holding/releasing a
second time and, depending on the receiver
model, even a third time.
> Programming is now be complete and the
garage door, gate or similar should now
be activated when the programmed but-
ton is depressed.
In the event of programming problems, contact
HomeLink
®
at www.HomeLink.com, or call
00 8000 466 354 65 (or the toll number
+49 6838 907 277)
33 .
Reprogramming individual buttons
To reprogram an individual HomeLink
®
button,
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2. Once the indicator lamp on HomeLink
®
starts to flash slowly, programming can con-
tinue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved programming.
Resetting the HomeLink
®
buttons
It is only possible to reset all of the HomeLink
®
buttons at the same time, not each button indi-
vidually. Individual buttons can only be reprogram-
med.
–
Press and hold depressed the outer buttons
(1 and 3) on HomeLink
®
for approx. 10 sec-
onds.
> When the indicator lamp changes over
from a constant glow to starting to flash,
the buttons are reset and ready to be
reprogrammed.
Related information
• Using HomeLink
®
*
(p. 472)
• HomeLink
®
*
(p. 469)
• Type approval for HomeLink
®
*
(p. 472)
32
Button designation and colour varies between manufacturers.
33 Note that the toll-free number may not be available depending on operator.