Volvo V90 2019, Owner'S Manual

Page: 472 / 674

STARTING AND DRIVING
* Option/accessory. 470
Programming HomeLink
®
*
31
Follow these instructions to program
HomeLink
®
, reset all programming or reprogram
individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position" before
HomeLink
®
can be programmed or used. If
possible, fit new batteries in the remote con-
trol that shall be replaced by HomeLink
®
for
faster programming and improved transmis-
sion of the radio signal. The HomeLink
®
but-
tons should be reset before programming.
WARNING
While programming HomeLink
®
, the garage
door or gate being programmed may activate.
For this reason, make sure that nobody is in
the vicinity of the door or gate while program-
ming is in progress. The car should be outside
the garage while a garage door opener is
being programmed.
1. Aim the remote control towards the
HomeLink
®
button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indicator
lamp on HomeLink
®
.
Note: The ability of some remote controls to
program HomeLink
®
is improved at a dis-
tance of approx. 15-20 cm (approx. 6-12
inches). Bear this in mind if problems occur
with the programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
®
.
3. Do not release the buttons until the indicator
lamp has switched from flashing slowly
(approx. once per second) to either flashing
quickly (approx. 10 times per second) or illu-
minating with a constant glow.
>
If the indicator lamp illuminates with a
constant glow:
Indication that the pro-
gramming has finished. Press the pro-
grammed button twice to activate.
If the indicator lamp flashes quickly:
The device to be programmed to
HomeLink
®
may have a security function
that requires extra steps. Test by pressing
the programmed button twice to see
whether the programming is working. Oth-
erwise, continue with the following steps.
31 Applies to certain markets.