Volvo L20B, Owner'S Manual

Page: 54 / 110

Travel
52 Attaching and removing attachments
A Cock valve in position "Open"
B Cock valve in position "Closed"
C Locating pin
D Locking pin
Note:
When using a road sweeping machine lever (2) must be
locked in rear position.
Removing the working attachment
– Lower the working attachment flat to the ground.
– Shut the engine down.
– Shift lever (2) several times forward and backwards to relieve
the pressure.
– Disconnect the hydraulic quick couplings on the working
attachment from the quick couplings on the equipment carrier.
– Turn the cock valve on the attachment carrier to position (A).
– Start the engine.
– Shift lever (2) forward, until the locking pins are fully retracted
from the receiving bores in the working attachment.
– Operate lever (1) to "Tipping" and "Lowering", until the locating
pins of the SW-carrier are free.
– Shift lever (1) to middle position (neutral).
– Drive the loader backwards away from the working attachment.
ATTENTION!
Check whether the working attachment is properly locked
and secured by actuating lever (1) from "Tipping back" fully
to "Tipping".
ATTENTION!
If the working attachment does not stand firmly without any
additional supports, it must be secured before unlocking so
that nobody is endangered.
M200054A
2
1
M300049A
C
D
A
B