Volvo L20B, Owner'S Manual

Page: 52 / 110

Travel
50 Attaching and removing attachments
Attaching and removing
attachments
Installation and removal of quick change
working attachments without additional
hydraulics
Install the working attachment (e.g. bucket, load-
ing fork etc.).
– Drive the loader forward up to the working attachment.
– Turn the cock valve on the attachment carrier to position (A).
– Shift lever (1) to "Lifting", until the centring pins (C) of the
SW-carrier (see illustration) have picked up the working
attachment.
– Actuate lever (2) "Tipping back", until the working attachment
lifts off the ground.
– Shift lever (2) backwards until the locking pins (D) protrude from
the receiving bores of the working attachment for approx.
10 mm.
– Shift lever (2) to middle position (neutral).
– Shut the engine down.
– Turn the cock valve on the attachment carrier to position (B).
A Cock valve in position "Open"
B Cock valve in position "Closed"
C Locating pin
D Locking pin
ATTENTION!
Check whether the working attachment is properly locked
and secured by actuating lever (1) from "Tipping back" fully
to "Tipping".
M200054A
2
1
M300051A
C
M300049A
C
D
A
B