R8703683
34
R8703684
Position the heater for installation
Take a small hose clamp (from the kit) for the fuel line. Install the
clamp on the fuel hose (1) from the fuel pipe on the sub-frame
Press the fuel line on the inlet (2) on the fuel pump (FP). Tighten.
35
D8703767
Position the bracket (1) (from the kit) on the screw (2) protruding
in the wheel arch
Take a nut from the kit. Finger tighten
Install the heater and the bracket (3) in the left front mounting on
the sub-frame. Use the screw (4) from the kit. Finger tighten
Turn the bracket (1) so that its hole is aligned with the screw
underneath the hole in the bottom of the bracket (5)
Secure both brackets using the screw and nut from the kit.
Finger tighten
Check that the heater does not catch on any surrounding
components
Tighten the heater to the sub-frame and the brackets
Tighten the screw (4). Tighten to 105 Nm (78 lbf.ft). Angle-
tighten 120° or MAX 280 Nm (206 lbf.ft.)
Remove the protective cover from the pre-routed connector (6).
Press in the catches on the top of the connector to release the
cover
Connect the cable from the heater to the connector
Remove the mobile jack.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Fuel driven heater 912-D- 8698855 - V1.0
Side 17 / 24