8.
Pry out bottom front edge of rear side panel (near
scuff plate
) to
release retaining clip (Figure 3, previous page).
9.
Pry out rear edge of rear side panel to release retaining clips.
10.
Pull rear edge of panel out over 10mm stud. Work panel up and out
enough to disconnect cable.
11.
Pry
metal clip
off
convertible top cover cable
. Pry
cable end
off
stud (Figure 4).
12.
Disconnect flap motor and tweeter harnesses. Set panel aside.
13.
Remove four (4) tamper-proof Torx T20 screws securing speaker.
Pull out speaker, disconnect and remove.
Note:
A tamper-proof
Torx driver will be required.
14.
Connect speaker wiring adaptor of replacement speaker to vehicle
speaker harness. Secure speaker with screws previously removed
(Figure
5).
15.
Test speaker operation and reassemble rear of vehicle by reversing
removal
steps.
Rear Speakers -- Convertible
(continued)
055 0005
8
FIGURE 5
FIGURE 4
Metal Clip
Cable End
Make sure seats are secured to manufacturer's specifications.
SAFETY CHECK
Convertible Top Cover Cable
1-800-955-9094
TECHNICAL SUPPORT
!
