055 0005
Receiver Installation
(with trim ring)
4
1.
Connect receiver wiring adaptor to receiver following instructions supplied with
wiring
adaptor.
2.
Remove
DIN sleeve
and
trim ring
from receiver (Figure 1).
3.
Place
receiver faceplate “B”
(supplied with installation kit) into receiver
opening.
4.
Slide DIN sleeve through opening in faceplate and secure by bending the
securing tabs
(Figure 2).
5.
Hold receiver near dash. Connect receiver wiring
adaptor to factory harness. Plug antenna lead into rear of receiver.
If using an antenna adaptor:
Be sure the antenna cable (lead) is
plugged in and the blue power wire of the antenna adaptor is
properly
connected.
6.
Slide receiver fully into sleeve and test
operation.
7.
Install trim ring.
Receiver Faceplate “B”
FIGURE 2
FIGURE 1
DIN Sleeve
Trim Ring
Securing Tabs
Bend tabs after sleeve
is inside dash opening.
1-800-955-9094
TECHNICAL SUPPORT
Copyright 2012 Crutchfield Corporation
Please read first
•
Inspect factory receiver harness connector in vehicle.
Ensure that the wiring adaptor received from Crutchfield
plugs into the vehicle’s connector. If the connector is
missing or incorrect, please call our
Technical
Support Department
at
1-800-955-9094
.
NOTES: