engine with coolant.
OIL PAN
Oil pan can be removed and installed with engine in vehicle. No further information is available from
manufacturer.
OVERHAUL
CYLINDER HEAD
Cylinder Head
Clean all gasket mating surfaces. Check cylinder head for warpage. See
CYLINDER HEAD
table under
ENGINE SPECIFICATIONS.
Valve Stem Oil Seals
Valve stem oil seals may be replaced with cylinder head installed. On ABA engine, install seals using Valve
Seal Driver (10-204). On AEG engine, install valve seals using Valve Seal Driver (3129).
Valve Springs
Information is not available from manufacturer.
Valve Guides
1. Using dial indicator, check valve stem-to-guide clearance (wobble). See
CYLINDER HEAD
table
under ENGINE SPECIFICATIONS. To replace valve guide, press guide out from camshaft side.
Replacement valve guides have shoulder on camshaft end. Press replacement guides out from
combustion chamber side.
2. Lubricate new valve guides with oil. Using Valve Guide Installer (3121), press valve guide in cold
cylinder head as far as guide will go from camshaft side. DO NOT exceed one ton pressure. Using
Valve Guide Reamer (3120), ream guides to proper stem-to-guide clearance (wobble). See
CYLINDER HEAD
table under ENGINE SPECIFICATIONS.
Valve Seats
1. Check valve seats before any other cylinder head service. Insert valve and hold firmly against valve
seat. Measure distance between valve stem tip and valve cover surface. See
Fig. 33
.
NOTE:
On ABA (except Beetle) engine, cracks .02" (.5 mm) wide or less between
valve seats or between valve seat and spark plug threads are considered
acceptable by manufacturer. On AEG engine, cracks .01" (.3 mm) wide or
less are acceptable.
1995 Volkswagen Golf III GL
2.0L 4-CYL
1
января
2005
г
. 1:19:01
Page 44 © 2004 Mitchell Repair Information Company, LLC.
