Vogt HEC-10, Service Manual

Page: 17 / 114

HEC-Series Service Manual
RECEIPT OF YOUR TUBE-ICE MACHINE
10/23/01
2-1
2. Receipt Of Your Tube-Ice Machine
! WARNING !
Only service personnel experienced and certified in refrigeration and qualified to work
with high voltage electrical equipment should be allowed to install or work
on this Tube-Ice
®
machine.
! WARNING !
Inspection.
As soon as you receive your machine, inspect it for any damage. If damage is
suspected, note it on the shipper’s papers (i.e., the trucker’s Bill of Lading). Immediately make a
separate written request for inspection by the freight line’s agent. Any repair work or alteration to
the machine without the permission of the Henry Vogt Machine Co. can void the machine’s
warranty.
The machine was shipped with a full charge of HCFC-22 stored in the receiver. Visually check all
lines for mechanical damage. If a leak is suspected, check all joints with a Halogen Leak Detector.
All leaks should be reported to the Henry Vogt Machine Co. to obtain authorization for repair.
Safety Valves. Two safety pressure relief valves are an integral part of the packaged Tube-Ice ®
machine. One is located in the low-side of the system on the freezer and one is in the high side of
the system on the receiver. You must vent each of the pressure relief valves to the atmosphere in
such a manner as to comply with local and national codes.
Machine Room. The machine must be located inside a suitable building and must not be subjected
to ambient temperatures below 50
?
F (10
?
C) or above 110
?
F (43.3
?
C). Heat radiation from other
sources (sunlight, furnaces, condenser, etc.) and unusual air current may affect the operation of the
machine and should be avoided.
The electrical components of the Tube-Ice ® machine are rated
NEMA 1. Therefore, the machine should not be located in a hazardous area.
Storage (prior to installation or start-up).
The machine must not be stored or installed in an area
that is subject to reach temperatures at or above 115
?
F (46.1
?
C).
Important Notice. The Warranty/Registration Start-Up Report must be completed and returned to
the Henry Vogt Machine Co. to initiate and assure a full warranty.