G-700
18
This internal pattern can’t co-exist with OSD menu. During geometry adjustment, user needs to select
adjusting item, then click [Enter] to pop-up grid pattern.
If user wants to use external grid pattern from PC or
other signal sources or see OSD menu instead of internal grid pattern, user can continuously click pattern
key to show it
. A flashing indicator at the adjusting point will appear. User can see real time grid pattern
change during the adjustment. It is recommended to connect through digital interface (HDMI or DVI) to the
projector to avoid position shift after installation.
If user wants to show the adjustment value (pixel #) while doing geometry alignment, user can continuously
press [Pattern] key to show the adjusting value.
Note: The grid size of G-700 is 32x32 pixels and some GeoBox model is 50x50 pixels. If user wants to do
edge blending with G-700 and other model, user needs to apply external grid pattern so that all GeoBox will
show the same grid pattern. Please download [Edge Blending grid pattern] from VNS website. Continuously
press [Pattern] hotkey, user will show the same external pattern in all projectors for easy geometry
alignment. If user uses Gwarp PC tool, user can set grid size to 50x50 to get the same grid size in all
projectors.
8 OSD menu and operations
4 processing channels will share the same OSD Menu keys and remote controller. Please select the
channel # through front panel key pad or CH1-CH4 hot keys on the remote controller to operate OSD
menu in each channel.
8.1 OSD simultaneous control in all channels
a.
[All] function: Allows user to control all channels in G-700 simultaneously. When press [All] function key
and functional hot key, the system will execute the same OSD command to all channels.
b.
[All] enable keys:
•
Remote controller: [CH A/B]
•
Front panel: [All] menu key
c.
LED Indicator: When [All] is activated, all channel LEDs on Front panel will show up.
d.
[All] function will be functional in the first level of OSD in below OSD menu
Internal grid pattern can be displayed
after press [PATTERN] key. External
pattern can also be applied.
When use Gwarp PC tool for geometry
alignment, user can change grid size.
Please press channel selection key to
switch among different channels.
Press [Exit] to exit from grid pattern.
