G-700
9
851: control GeoBox ID No. 1
853: control GeoBox ID No. 3
n.
OSD Lock / Unlock: When continuously press [Menu] key on Front Panel or IR Remote Controller
for 5 seconds, the OSD function will be locked to prevent all channels from setting change by
negligence. To press [MENU] key for 5 seconds again, it will unlock OSD. If you lock from remote
controller, you can unlock from Menu key on front panel and vice versa.
o.
[Image Setup] menu will not be activated if the input source is not from VGA.
p.
Please reset GeoBox before any new application to avoid unexpected settings in the system.
OSD Reset function will only apply to one channel only. If user wants to reset all channels at the
same time, please insert small pin into RESET hole at the back panel for 5 seconds to reset them.
q.
To set [Menu Time Out] to “0”, the OSD will appear till the OSD Menu has been turned off
manually or system input timing change.
r.
User can turn off output signal to projector through [Standby Time out] setting. Once no input
signal is detected, GeoBox will turn off output signal automatically after preset time.
s.
Default Internal Grid Pattern represents 32x32 pixels no matter which input resolution is selected.
t.
Only HDMI input port can provide HDMI raw signal loop out for daisy chain connection. This loop
out signal has no any processing.
u.
When [Gwarp] PC tool is used, user needs to save the setting into GeoBox through the OSD
menu: [Anyplace]
[Gwarp Pro]
select [UserMap 1-10] to save the settings. Then PC can be
removed. The saved settings include geometry and color uniformity information.
v.
When Power Off/ON GeoBox, it will maintain the final settings.
w.
User needs to save the final setting into [Profile] under [Options] menu for long tern stored inside
the system. Even the system is reset, the [Profile] settings will be kept without change.
x.
Continuously press PATTERN button, internal test pattern will show different colors for easy
installation: White—Red—Green—Blue—Blank. When in “Blank”, user can see OSD and the
image from signal source. In this case, PC test pattern can be applied.
y.
Please use INFO hot key on front panel or remote controller to check the input and output timing.
The indicators on the front panel will show the input/output connection status.
z.
When OSD is activated and user switches to another processing channel, the OSD will stay active.
Once user switches back to this channel again, user can operate the same OSD menu again. This
is convenient for geometry alignment. User can pop-up the same geometry menu (such as 9x5) in
both processing channels and switch between two channels for quick geometry alignment.
aa. User can check the LED indicator on the front panel to know the status of the input signal and
output connection. If all orange and green LED are lighted up, it means G-700 has detected the
input signal source and output connections. The system connection should be correct.
