39
H8030 Home Theater Projector - User Manual
Change Lamp
The lifecycle of ordinary projection lamp typically lasts for 2000 hours (Normal mode),
4000 hours (Economy mode) before requiring replacement (different lamp configurations
will affect lamp life). From the OSD Menu to check how long a lamp has been used. You
should also replace the lamp when the projected image gets noticeably darker. Contact
your local dealer to purchase new certified lamps for your projector.
To replace the projector lamp
1. Turn off the projector and unplug the power cord. Let the projector cool for
approximately 60 minutes before removing the lamp module for replacement.
When you turn off the projector, the lamp inside the projector will still be very hot
(approximately 200 ~ 300°C). If you at- tempt to replace the lamp without allowing the
projector to cool, you could risk scalding yourself. This is why you should wait for no
less than 60 minutes for the lamp to cool down in order to perform the replacement
safely.
2. Loosen the lamp cover.
3. Use a screw driver to loosen the screws
as shown in the illustration.
4. Grasp the metal rod on the lamp cover
and pull the lamp out.
5. Insert the new lamp in the direction
shown in the illustration into the lamp
assembly; tighten the two screws using
a screw driver and make sure the lamp
is firmly secured to prevent the lamp
from shaking or poor contact.
6.
Replace the lamp cover and firmly
secure the two screws on the lamp
cover.
Summary of Contents for H8030
Page 1: ...H8030 User s Manual ...
