Vivax cool ACP-12CC35GECI, Service Manual

Page: 62 / 190

A/A DC INVERTER U-MATCH AIR CONDITIONERS INSTALLATION
83
swing motor lead wire get caught in the sealing material.)
‹ Screw all 4 hexagon head screws located right beneath the latches in approximately 15mm.(Panel will rise)
‹ Adjust the panel by turning it to the arrowed direction in Fig.4 so that the ceiling opening is completely covered.
‹ Tighten the screws until the thickness of the sealing material between the panel and the indoor unit body is
reduced to 5~8 mm.
2
）
Precautions:
‹ Improper screwing of the screws may cause the troubles shown in Figure 1-3-14.
Figure 1-3-14
‹ If gap is still left between the ceiling and the panel after screwing the screws, readjust the height of the indoor
unit body (Refer to Figure 1-3-15)
Figure 1-3-15
‹ After fixing be sure no gap left between the ceiling and the panel
3
）
Wiring of the decoration panel.
‹ Connect the joints for swing flap motor lead wire (at 2 places) installed on the panel (Refer to Figure 1-3-16)
Figure 1-3-16
Contamination dew condensation,dew dripping
Air leak
Air leak from ceiling
No gap is allowed