Vitek VT-1424 BK, Manual Instruction

Page: 4 / 24

4
ENGLISH
•
Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center at the contact addresses
given in the warranty certificate and on the
website www.vitek.ru.
•
To avoid damages, transport the unit in origi-
nal package only.
• Keep the unit in a dry cool place out of reach
of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature, keep it for at least three hours
at room temperature before switching on.
–
Unpack the unit and remove any stickers that
can prevent unit operation.
–
Check the unit for damages; do not use it in
case of damages.
–
Make sure that the operating voltage of the
unit corresponds to the voltage of your mains.
–
Wash the attachments (5, 6) with warm water
and neutral detergent, rinse them and dry.
–
Clean the mixer body (4) with a soft, slightly
damp cloth and then wipe it dry.
ATTACHMENTS
Beating/mixing attachments (beaters) (5)
Use the beaters (5) for beating cream and egg
white, making biscuit dough, puddings, cock-
tails, whipped cream, mayonnaise, puree and
sauces.
Dough hooks (6)
Use for kneading «heavy» dough and mixing
minced meat.
Note:
• Do not use the beater (5) and the dough
hook (6) at the same time.
BUTTONS DESCRIPTION
–
The attachment release button « EJECT » (1) is
used for removing the attachments (5) or (6).
–
Use the operation mode switch (2) to select
the desired attachment rotation speed
«
1, 2, 3, 4, 5 ».
–
The button « TURBO » (3) is used for switching
the maximal speed on.
USING THE UNIT
• Make sure that the power cord plug is not
inserted into the mains socket, and the opera-
tion mode switch (2) is set to the position
«0» .
• Insert the beaters (5) or the dough hooks (6)
into corresponding mixer (4) sockets until
clicking. Both attachments should be fixed
properly in the mixer openings.
• Insert the power plug into the mains socket.
• Switch the mixer on with the operation mode
switch (2) and select the desired attachment
rotation speed «
1, 2, 3, 4, 5 ».
• If you press and hold down the “TURBO” but-
ton (3), the unit will operate at maximum rota-
tion speed.
•
After unit operation, set the operation mode
switch (2) to the position
«0» and unplug the
unit.
•
Press the button (1) to release the installed
attachments (5 or 6).
Attention! Do not press the attachment
release button (1) during the unit operation.
Notes:
–
Maximal continuous operation time is no lon-
ger than 5 minutes; make at least a 10 min-
ute break before switching the unit on again.
–
Do not block the ventilation openings on the
unit body, this may lead to the electric motor
overheating.
RECOMMENDED OPERATION MODES
Product type
Recommended
product amount
Attachment
rotation
speed
Approximate
operation
time
Used attachments: beaters (5)
Beating egg whites 6 4-5 2-4 min.
Whipping cream 300 ml 1-5 4 min.
Mixing ingredients for dough 400 g 1 - 5 1.5 – 2 min
Beating butter 400 ml 4 - 5 1 min.
IM VT-1424.indd 4 27.11.2017 14:58:51