VisuNet XT-9700, User Manual

Page: 29 / 81

VisuNet XT 9700 Series
Connectors and Cabling
Vi
suNet
XT
9
700
Seri
es
27
5 Connectors and Cabling
This section describes the connectors and cabling on the VisuNet XT-9700.
Connectors are located on the rear I/O plate. All cables to the I/O plate must be routed through
the cable glands on the junction box.
Input and output wiring methods must be in accordance with local wiring methods and codes,
the authority having jurisdiction, and the manufacturer recommendations.
All cables brought through the cable glands must be supported to avoid forces or movement of
the cables in the glands. Mount cable supports to the VisuNet housing or to the mounting
supports.
All cabling is to be routed in grounded conduit.
All high voltage lines above 300 V must be separated from low voltage lines.
5.1 Junction Box
The VisuNet XT provides different pass through cable glands for cable connections (required
to maintain the enclosure protection rating). These glands are gas and water tight and must be
tightened with a torque described in the manufacturer’s instructions. Figure 5.1 identifies the
available I/O glands.
5.1.1 With Quick Disconnects and Cable Glands
Figure 5.1 Junction Box with quick disconnects and cable glands
Caution!
Modifying the junction box or the cable glands invalidates enclosure protection and
certification.
No. Description No. Description
1 WIFI antenna connectors (SMA) 4 USB Type A
2 M20 cable gland for power 5 USB Type A
3 M16 cable gland for customer choice 6 RJ45 LAN connection