VisuNet XT-9700, User Manual

Page: 26 / 81

Vi
suNet
XT
9
700
Seri
es
24
VisuNet XT 9700 Series
Hardware Installation
4.2.2.2 VESA Mount Installation
On the back side of the XT unit is a 100 mm VESA mount for attachment to pedestals, wall
arms, ceiling arms, or wall mount brackets. Use M5 x 12 mm long hex head screws (item 1)
and lockwashers (item 2) for VESA mounting. Refer to Figure 4.11 .
Figure 4.11 VESA Mount
4.2.2.3 Panel Mount Installation
The VisuNet XT unit is designed for easy panel mounting in a control or machine cabinet. Use
the provided mounting accessory kit to secure the monitor from the inside of the cabinet. The
outer dimensions of the front bezel are as follows.
■
15-inch Display: 16.9 in. W x 13.9 in. H (430 mm x 353 mm)
■
19-inch Display: 19.4 in. W x 16.4 in. H (493 mm x 417 mm)
■
Maximum enclosure wall thickness: 0.375 in. (9.5 mm)
■
Panel cutout is 15.2 in. x 12.2 in. (386 mm x 310 m)
Prepare the panel cutout to the dimensions above and perform the following steps to install the
XT unit. Refer to FIG.
1. Install the gasket sections to the back of the XT unit, as shown in Figure 4.12 . The top and
bottom gaskets (item 2) are reversible , and the left and right gaskets (item 1) are
reversible.
2. Secure the right panel mount bracket (item 4) and left panel mount bracket (items 3)
together with #6-32 Phillips pan head screws (item 6) threaded into the Pemserts (item 5).
Tighten the screws to 1.2 Nm (11 in.-lb.). See Figure 4.13 .
Note!
A customer-supplied VESA steel mounting plate must be a minimum of 12 ga. thickness.