VisuNet XT-9700, User Manual

Page: 24 / 81

Vi
suNet
XT
9
700
Seri
es
22
VisuNet XT 9700 Series
Hardware Installation
Figure 4.5 Yoke frame clearance setup
2. Install the yoke by spacing the bearings as shown in the figure. Once placed within the
circular cutout, push in each sleeve bearing to lock the assembly in place. The plungers
can be locked in place to further aid installation.
3. Fasten the hinge shoulder screws using a 3/16" hex socket to 100in-lb. Refer to Figure 4.6 .
Figure 4.6 Yoke frame attachment
4. Install yoke base (#547305) to desired location. Thread the three thumb screws (3x
547638) into the tube section of the yoke frame.
5. Insert the frame into yoke base and tighten thumb screws by hand in desired position. Refer
to Figure 4.7 .
Figure 4.7 Yoke base
Yoke Keyboard Tray Assembly
1. Thread the plungers onto each threaded hole on the keyboard tray (547308). Insert a jam nut
(2x #547650) onto each plunger (2x 547644). Apply a small amount of Loctite 243
(#547659).
2. Place two of the smaller thrust bushings (2x 547641) onto each of the smaller shoulder
screws (2x #547657). Place one bushing (2x #547640) on each shoulder screw. Install
inwards on each side to the hinge hole on the keyboard tray.
3. Insert one thrust bushing (2x 547642) on each side. Next, place a spacer (2x 547655) on
each shoulder screw. See Figure 4.8 .
547306
547656
547645
.05 max.
Protrusion
Separate
bearings
547306
547638
547305