VisuNet XT-9700, User Manual

Page: 22 / 81

Vi
suNet
XT
9
700
Seri
es
20
VisuNet XT 9700 Series
Hardware Installation
■
Panel Mount: The VisuNet XT can be mounted in a panel opening using a Panel Mount
Kit. Refer to 4.2.2.3 .
Each method requires its own accessory components to assist in mounting.
4.2.2.1 Yoke Mount Installation
Shield Assembly
1. Attach side plates (#547303 and #547302) to the shield (#547309) through the pivot hole lo-
cation, aligning stop pin into the guide slot. Place two thrust bushings on each side (4x
#547642) on both sides of the shield flanges and insert the pivot bearing (2x #547640) throu-
gh the shield and thrust bushings. Place one washer (2x #547646) and one locknut (2x
#547647) on each stud and tighten to 14in-lb. See Figure 4.1.
Figure 4.1 Shield Assembly
2. Using one retractable plunger (2x #547644) per side, inert jam nuts (2x #547650) onto the
plunger threads then install into threaded hole on shield side plates. Apply Included Loctite
243 (#547659) to the threads of the plungers. Adjust the depth such that the thread end of
each plunger (the nose when the plunger is retracted) leaves a .03"-.05" gap from the shield
sides as shown. Tighten jam nuts to 30in-lb to secure in place. Refer to Figure 4.2 .
Figure 4.2 Shield lock gap adjustment
Yoke Adapter Assembly
1. Attach adapter blocks (2x #547304) to the side of the XT using two socket cap screws (4x
#547654) for each block. Apply Loctite 243 (#547659) to threads prior to engagement. In-
sert into the two outer through holes and the outer two threaded holes on the side of the XT.
Using a 3/16" hex socket, tighten each to 36in-lb. NOTE: Orient the right side block to ensure
the pockets are aligned to the XT side cover screws to allow proper fit. See Figure 4.3 .
547309
547646
547640
547647
547642
547650
547644
547303
547309
547650
547644
547303
.01-.03 Gap