64
VK2-600PTZ User manual
VIEW ANGLE SETUP
PANNING RANGE
FLIP
: 90
TILT LIMIT : OFF
SAVE AND EXIT(ESC TO CANCEL)
FLIP
: OFF, AUTO, 90 , 100 , 110 , 120
OFF:
the dome camera moves until 90 vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At
that time, release the Joystick instantly and pull it down again to run the auto-flip function.
When you use the panning range, we recommend using the flip mode to AUTO.
90 , 100 , 110 , 120 :
allows the image to flip digitally when the camera moves over the
setting angle vertically.
TILT LIMIT:
This option has been designed to limit the view angle as there is some obstruction in
zooming out on specific area of the tilt angle.
ON:
When this option is enabled, the range of the tilt angle will be limited to 10 degree.
This can prevent from obstruction or bad focus problem caused by the horizontal line of
the semi sphere in the bubble.
OFF:
When this option is disabled, the range of the tilt angle will not be limited.
When you zoom out within the range of the tilt angle, you will see the horizontal line of
the semi sphere in the bubble.
• INITIALIZE DATA
Use the
Joystick
to move the cursor, right to select sub menu (if applicable) and
(Tele/Wide)
to
adjust.
To save changes highlight ‗SAVE AND EXIT‘ and move
Joystick
right.
Joystick
left
exits without saving.
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)
FACTORY DEFAULT
Select
‗FACTORY DEFAULT‘ to initialize the Data.
Use the
Joystick
to move the cursor and right or
(IO/FN)
to accept selection.
FACTORY DEFAULT
ARE YOU SURE ?
CANCEL
OK
ERASE PROGRAMMED DATA
Summary of Contents for VK2-600PTZ
Page 1: ...Configuration and User manual ...
Page 2: ...II VK2 600PTZ User manual ...
Page 79: ...72 VK2 600PTZ User manual Figure Dimension ...
Page 83: ...76 VK2 600PTZ User manual ...
