63
VK2-600PTZ User manual
(AREA TITLE) (AF AE)
(FUNC TITLE )
(CTRL KEY TO MOVE)
SAVE AND EXIT(ESC TO CANCEL)
(ALARM MESSAGE) DOMEID…XXXX
XXX.X
XXX.X
• VIEW ANGLE SETUP
Use the
Joystick
to move the cursor and
(Tele/Wide)
to adjust. To save changes highlight
‗SAVE AND EXIT‘ and move
Joystick
right.
Joystick
left exits without saving.
PANNING RANGE (Electronic Limit Stops)
If the Dome is installed close to a wall or public boundary whereby the camera needs to be
restricted from viewing this area then the panning range can be set up to stop this.
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
1. Select
‗RIGHT LIMIT‘. Press the
(IO/FN)
key, then
‗CTRL‘ is displayed. Move to the desired
position. Press the
(IC/FF)
key then the
‗CTRL‘ disappears.
2. Select
‗LEFT LIMIT‘. Press the
(IO/FN)
key, then
‗CTRL‘ is displayed . Move to the desired
position. Press the
(IC/FF)
key then the
‗CTRL‘ disappears.
3. Select
‗ENABLE‘. Set to ON - adjust with
(TELE/WIDE)
4. Select
‗SWAP‘. Set to ON, to swap the start RIGHT & LEFT LIMITS - adjust with
(TELE/WIDE)
5.
To save changes highlight ‗SAVE AND EXIT‘ and move
Joystick
right.
Joystick
left exits
without saving.
NOTE:
The Dome needs to be under the 90 degree vertical. When the flip mode is 90 , 100 ,
110 or 120 and you move over 90 vertically, the panning range operates on the
opposite side.
Summary of Contents for VK2-600PTZ
Page 1: ...Configuration and User manual ...
Page 2: ...II VK2 600PTZ User manual ...
Page 79: ...72 VK2 600PTZ User manual Figure Dimension ...
Page 83: ...76 VK2 600PTZ User manual ...
