56
VK2-600PTZ User manual
2. Press the
(IO/FN)
key
then the
‗CTRL‘ displays. Move the Dome through the required field of
view applying zoom if required - the Dome movement will be automatically recorded. Press the
(IC/FF)
key
then
‗CTRL‘ disappears.
3.
To save changes highlight ‗SAVE AND EXIT‘ and move
Joystick
right.
Joystick
left exits
without saving.
4. Select ‗TITLE‘ – this can be changed one of two ways:
Moving the Joystick left and right to select the cursor location and
(TELE/WIDE)
to
change the character
Use the Joystick to move and navigate the cursor to the alpha numeric character
table displayed and select the required character with the
(IO/FN)
keys.
NOTE:
The 200 seconds can be used per Pattern. Each movement uses memory to store the
change
– the % column show show much of the total pattern memory has been used for
each tour and also gives the running total at the bottom. The Pattern memory does not
have to be evenly distributed across all of the Patterns.
4.8 Area Title
Enter a specific name on a programmed angle between START and END. E.g. For the screen
below, when the camera points at an angle between 124.3 (PAN), 30.7 (TILT) to 359.5 (PAN),
45.4 (TILT), ABC will be displayed on the screen.
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3 30.7
END ANGLE : 359.5 45.4
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
NUMBER
: 01-08
TITLE
: up to 12 characters.
SWAP
: Swap the start point for the end point.
Follow steps below to program the Area Title:
1. Select
‗NUMBER‘ and set the desired number by moving the
Joystick
to the left or right.
2.
Select ‗TITLE‘ – this can be changed one of two ways:
Moving the Joystick left and right to select the cursor location and
(TELE/WIDE)
to
change the character
Use the Joystick to move and navigate the cursor to the alpha numeric character
table displayed and select the required character with the
(IO/FN)
keys.
3. Select
‗START ANGLE‘. Press the
(IO/FN)
key, then
‗CTRL‘ is displayed. Move to the desired
position. Press the
(IC/FF)
key then
‗CTRL‘ disappears. To adjust at the 0.1 degree interval,
twist the
Joystick
at the pan field and the tilt field.
Summary of Contents for VK2-600PTZ
Page 1: ...Configuration and User manual ...
Page 2: ...II VK2 600PTZ User manual ...
Page 79: ...72 VK2 600PTZ User manual Figure Dimension ...
Page 83: ...76 VK2 600PTZ User manual ...
