Vista VK2-600PTZ, Configuration And User Manual

Page: 57 / 85

50
VK2-600PTZ User manual
DOME MENU
AUTO SCAN
PRESET
TOUR
PATTERN
AREA TITLE
PRIVACY ZONE
CAMERA
DOME SETUP
DOME COMMUNICATION
EXIT (ESC TO EXIT)
4.3 Auto Scan
Allows the Dome to be set up to move automatically between 2 programmed locations, the Auto
Scan can be recalled from the controlling device using the AUX6 command.
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- -----
END ANGLE : ----- -----
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
SAVE AND EXIT(ESC TO CANCEL)
NUMBER : 01 (cannot be changed
– only 1no Autoscan is available).
TITLE : Up to 12 characters.
MODE : NORMAL, VECTOR, RANDOM.
NORMAL : Moves from the start point to end point using only pan.
VECTOR : Moves from the start point to end point linearly applying pan, tilt and zoom.
RANDOM : Moves randomly between the start angle and the end angle.
SPEED : 01~13 steps, the lowest number means the slowest speed.
START ANGLE : The 1
st
set of digits relates to the pan position, the 2
nd
set of digits relates to
the tilt position.
END ANGLE : The 1
st
set of digits relates to the pan position, the 2
nd
set of digits relates to the
tilt position.
SCAN DIR : Set the Scan direction, CCW (Counter Clock Wise), CW (Clock Wise).
SWAP : Swaps the start angle for the end angle.
DWELL : Sets the dwell time at the start & end points, between 01~99 seconds.
Follow steps below to set up the Auto Scan:
1. TITLE
– this can be changed one of two ways:
Moving the Joystick left and right to select the cursor location and (TELE/WIDE) to
change the character.