0150-0319A 14
Vista
Triplex
2
CDR/DVD
It is important that the power-up procedures be followed carefully. The unit uses its auto-detect
feature to detect camera signals during power-up, and configures itself automatically.
Power-up procedure
Power Supply Input
Once the system installation is complete, apply
power in the following order:
1.
Energize the monitors and all of the cameras.
2.
Energize the Vista Triplex
2
CDR/DVD.
Voltage:
12 Volt DC
Power:
60 Watt (5 Amp)
Connector:
2.1mm barrel, centre positive
Once power is applied to the unit, it will begin its power-up procedure. The unit will begin by displaying
the software version on Monitor-A, and then the unit will be ready for operation.
Check Video Input Quality
Check the picture quality by selecting each camera for full screen display. If the picture quality is poor,
check the following items:
•
The BNC connections.
•
The loop-through terminations.
•
The video levels of incoming signals.
•
The possibility of ground loops.
•
Consult the camera’s installation instructions for additional information about proper camera setup.
Check Record And Playback Quality
Record for at least three minutes at the default record rate
.
Then play back the recording, selecting
each camera for full screen display. Check the playback picture quality.
AUX Port
The back panel is equipped with an Aux Port (DB-9
style connector).
Do not attempt to wire directly to the DB-9
connector on the back panel.
1
5
6
9
DB-9 Connector on Back Panel
Connect the Accessory PCB to the AUX port to access the Audio features. Wire the audio input and
output to the Accessory PCB per the pin out specifications shown below.
Pin 1:
Not Used.
Pin 2:
Audio Out.
Pin 3:
Ground.
Pin 4:
Audio In.
Pin 5:
Ground.
Pin 6:
Not Used.
Pin 7:
Ground.
Pin 8:
Not Used.
Pin 9:
Ground.
GND:
Ground.
1
2
3
4
5
6
7
8
9
GND
Accessory PCB
Summary of Contents for Triplex2
Page 88: ...0150 0319A...
