Vision 1330B, Owner'S Manual, Page: 38 / 48

Úåå+)2!-%+å).#
This wire must be connected to the (+)
12v Ignition line (showing 12v when
IG switch is turned on). The connec-
tion of this wire is vital for triggering
the siren when the ignition goes on
(while armed) or for remote start com-
patibility, and for Force Reset (aka,
“manual disarm”).
( '2.7(4åWIREå å)GNITIONå)NPUT
THE 14-PIN MAIN HARNESS
H1
H1
'2.7(4
34
/.
!##
/&&
)'.)4)/.
37)4#(
This wire supplies a (+)12v (6A max.) output for flashing the vehicle’s haz -
ard (turn signal) lights during security breaches (i.e., at times of Warning
Chirps and Full Siren Blast). See Fig-3 below.
( '2.åWIREå å,IGHTå&LASHå/UTPUT
6%()#,%
(!:!2$
37)4#(
./4%å
)TåDOESNTåMATTERåWHICHå'REEN
WIREåISåCONNECTEDåTOåTHEå,EFTåORå2IGHT
,%&4
452.
3)'.!,3
2)'(4
452.
3)'.!,3
H1
FIG-3: Connecting Light Flash
6EHICLE
(AZARD
&LASHå5NIT
'2.
'2.
This input wire detects if a door is opened. If opened while the 1330 is
armed, the siren will go off for 30 seconds or until disarmed. The White
wire can also be connected to the trunk if optional diodes are used. The con-
nection is made between the door (and/or trunk) switch and the dome (and/
or trunk) light as shown below in Fig-4 on the next page. The switches
shown are open-ciruit (no ground) when the door/trunk is closed.
(
7(4åWIREån å$OORå)NPUT
å./4%
If you connect to the door and trunk, keep in mind that the 2-
way pager will only flash the door icon when the door or trunk is opened.