Vision 1330B, Owner'S Manual, Page: 10 / 48

6)3)/.å"å/7.%23å'5)$%
System Operation
./#()20å-%4(/$åå
This method of disarming is identical to
the “Normal” method except there are
no siren chirps emitted after you dis-
arm. Press Pager Button-II or Button-III
then release. The doors will then unlock and hazard
lights will flash 3 times (if so installed). The Pager Remote will beep 2
times (or vibrate twice, if Vibe Mode is selected) , and icons will update (see
Fig-3 above). The system is now disarmed, and you may enter the vehicle
without triggering the siren.
()'(å3%#52)49å$)3!2-
When the system is “triggering” (warn-
ing chirps, siren blast, hazard flash),
two button presses are required to dis-
arm. This feature allows you to stop the
trigger condition with only 1 press while keeping the
system armed. You can press Buttons I or II or III (see note on next page) .
0USHå"UTTON
II
OR
III
!2-%$ $)3!2-%$
FIG-3: Pager LCD Icon Change After Disarming
$)3!2-).'
./2-!,å-%4(/$åå
This method is the typical way to disarm the
1330B, with confirmation chirps active. Press But-
ton-I on the Pager remote while the system is armed.
The doors will then unlock and hazard lights will flash
3 times (if so installed). The siren will chirp 3 times.
The Pager remote will beep 2 times (or vibrate twice, if in Vibe mode) , and
icons will update (see Fig-3 below). The system is now disarmed, and you
may enter the vehicle without triggering the siren.
0USH
"UTTONå I
0USHå"UTTON
I åORå II åORå III
)#/.3
&,!3(
3,/7,9