Vision 1330B, Owner'S Manual, Page: 11 / 48

Úåå+)2!-%+å).#
0ANICå-ODE
Panic Mode allows you to trigger the the full si-
ren blast from your remote, whether the system
is armed or disarmed. Press Button-I or Button-II
or Button-III for 3 seconds. (Note that Button-II ini-
tiates “Silent Panic.”) When you release, the pager icons will update as
shown in Fig-4 , and the pager will emit a siren tone (or vibrate). Vehicle
hazard lights will flash, the Status LED will flash quickly, and the siren
will go off for 30 seconds (siren will not go off if you pressed Button-II) .
You can exit Panic Mode (and silence the siren) 8 seconds after you
initate Panic Mode.
System Operation
0USHå"UTTON
I ORå II OR III
FORååSEC
./2-!,å0!.)# 3),%.4å0!.)#
FIG-4: Pager LCD Icon Change During Panic Mode
)#/.3
&,!3(
2!0)$,9
å./4% For the first 8 seconds after the pager siren tone (or vibration)
begins, you may not be able to disarm with only 2 presses. If you wait 8
seconds, two presses will always work (you can stop the siren with one
press, and disarm with the second). But during the first 8 seconds, how -
ever, it may take 3-5 presses before you can stop the siren and disarm.
4)0
The pager button you use to stop a trigger condition may change
the mode of the system. For example, if you armed with Button-II (“Silent
Mode”) and you later press Button-I while the system is triggered, trig-
gering will stop and the system will remain armed—but the system will
remain armed with the siren enabled. (The reason why is that Button-I
is “Normal Mode,” which enables the siren.)
Your first press stops the trigger (kills the siren, or kills hazard light flash
if in Silent Mode). Your second press disarms the system. (“2 presses” are
required to disarm whenever there is a system trigger, such as the siren go-
ing off.)