Vision 1330B, Owner'S Manual, Page: 13 / 48

6)3)/.å"å/7.%23å'5)$%
SYSTEM “ARMED” FEATURES
42)''%2å-%-/29
This feature informs you if the siren went off in your absence
and you were too far away for your 2-way pager to be updat-
ed about the alert. The Status LED flashes rapidly while the si -
ren is going off. When the siren stops 30 seconds later, the Status
LED will continue to flash rapidly until you disarm the system and turn on
the ignition (or until you disarm and then arm again).
When a vehicle sector (i.e., door, ignition, sensor) is triggered 8
times , the security system will automatically bypass that sector
until you disarm and arm the system again. This feature is use-
ful to prevent noise pollution caused by multiple siren triggers
in a short period of time. Parking near construction sites or having animals
jump on the vehicle can cause such shock sensor triggers to occur, espe-
cially if the sensitivity is set to maximum.
3"3å3ECTORå"YPASSå3YSTEM
$//2å42)''%2
The siren will blast for 30 seconds whenever a door is opened while the
system is armed. Vehicle hazard lights will flash if so installed, and your
pager will emit a siren tone and update icons as shown in Fig-6 below.
$//2å42)''%2
FIG-6: Pager LCD Icon Change Upon Door Trigger
)#/.3
&,!3(
2!0)$,9
34!4%å-%-/29
The 1330B remembers its armed or disarmed state if the vehicle’s battery
power is cut and later restored. However, if the system was armed when
the battery power was cut, the siren will go off when the power is restored.
(Siren will go off when power is cut only if siren is “battery backup” type.)