Vision 1330B, Owner'S Manual, Page: 23 / 48

Úåå+)2!-%+å).#
TROUBLESHOOTING
4(%å3%.3/2å3434!'%å42)''%2å)3.4å7/2+).'
Check the green LED on the shock sensor (or the 1st-Stage indicator
•
light on other sensors you have attached). If you never see the 1st-Stage
indicator light up, adjust the sensitivity and/or check the connector to
the sensor to ensure it is seated properly. Also check power connections
to the sensor. The ground (–) connection may be bad.
If you can see the indicator light on the sensor for the 1st-Stage trigger,
•
then it is likely a timing issue. After you connect the harnesses, wait 2
minutes before testing the sensor. If that doesn’t work, remember that
sensors are ignored for 3 seconds after arming. If that is not the issue,
check your wiring to the sensor.
-9å42!.3-)44%23å53%$å4/å7/2+å&).%å"54å./7å4(%9å$/.4
If you sent your vehicle in for maintenance and/or the battery was dis-
connected, or if substantial noise was present on the 12-volt line in the
vehicle, it is possible that transmitter memory could be lost. For this
reason we strongly recommend that the main wire harness of the 1330B be
disconnected BEFORE you disconnect the vehicle’s battery.
If the system is armed, please use your Force Reset Code to disarm the
•
system, then relearn your transmitters. (The Ignition and Door inputs
must be connected for you to do this.)
If the system is disarmed, assuming none of your remotes work, you
•
must consult your VISION dealer. The reason is that it is not possible
to re-learn new transmitters in this case without opening the control
module and accessing points on the circuit board. Since accessing the
circuit board is not covered under warranty, we advise consultation with
your dealer. Note however, that all your Program Features (de-
scribed on page 13) will be reset when your dealer relearns your
transmitters in this case. Note your settings first!
42!.3-)44%2å,/34åå7/22)%$å!"/54å3%#52)49
Simply relearn the transmitter(s) you have. Learning transmitters al-
ways erases previously learned transmitters from memory.
If you lost all your remotes, see “
-9å42!.3-)44%23å53%$å4/å7/2+
...”
above.
42!.3-)44%2å"!44%29å$)%$
Replacement batteries for the pager (1 AAA) and the 1-way transmitter
(2 CR2032) can be purchased at any convenience store.