10
Original phone
cradle and UHI
connector
2. Installation
2.1 Installing the Main Unit
ViseeO MB-4 is designed to work with a pre-installed UHI/MHI Comand system in
your vehicle. Therefore, you will need to locate the UHI/MHI connector which is
normally found in the tray under the front armrest.
If there is a phone cradle attached to the UHI/MHI connector, please
remove it first.
To remove the cradle:
1. Please make sure the vehicle engine is off.
2. Press the release button on your cradle (normally located at the top).
3. Remove the cradle from UHI/MHI connector with care.
Now install your MB-4:
1. Make sure there is no cradle attached to the UHI/MHI connector.
2. Press and hold the UHI release
button on your MB-4 then, gently slides
the MB-4 (UHI compatible socket side
facing downwards) onto the UHI/MHI
connector until it locks into the
connector.
3. Turn on the engine. MB-4's OLED
screen and the green LED should be
on to indicate the installation
successful.
UHI Connector
Press & hold the UHI Release Button
Summary of Contents for MB-4
Page 26: ...26 ...
