43: Configuring SAToP and CESoPSN
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
© Virtual Access 2018
GW6600 Series User manual
Issue: 1.7
Page 495 of 519
For analogue LL and X.21 and an unframed E1, the port configuration is the
configuration for that interface.
For a framed E1, the first port configuration is the configuration for the interface. The
first timeslot or group of timeslots, and subsequent ports configurations are the
configuration for further timeslots or groups of timeslots. All the ports have the same
devname in this case.
The examples below show a port section labelled ‘Port 1’.
config port 'Port1'
option enable '1'
option devname 'ttyLC0'
option udp_local_ipaddr '0.0.0.0'
option udp_remote_ipaddr '10.1.42.63'
option udp_local_port '5152'
option udp_remote_port '5152'
option rtp_payload_type '96'
option rx_jitter_buffer_size_ms '24'
option rate '64000'
option clock_recovery_enabled '1'
option packetization_latency '5'
…….
<port config also contains port specific options>
43.8.1
E1 interface settings
config port 'Port1'
option enable '1'
option devname 'ttyU0'
<generic port options>
…….
option e1t1_end '1'
option e1t1_line_code '1'
option e1t1_framing '2'
option e1t1_impedance '1'
option e1t1_timeslot '1'
option e1t1_protocol '0'
