Maxi 4875 and Midi 4845
Installation and User Manual
Page 15 of 40
Note
. Once the safe has been enabled to the use of the Electronic Key
(KEY=1), it will not be possible to open it with the previously set Area
Master Codes anymore. Safe could once again be opened with the previously
set Area Master Codes after having retrieved the KEY value to 0 only (that is
after having disabled Electronic Key). In order to set the KEY value to 0,
follow above described procedure but at point 3 press
0
.
A.2
How to associate (by means of a Password) the Electronic Key
with a previously set Area Master Code
To have some Electronic Keys enabled to open certain safes only (only 1
st
floor, only 2
nd
floor, etc.) and some other Electronic Keys enabled to open all
the safes, proceed as follows:
•
Unthread the plastic cap situated near the display, on safe door top
right corner and insert the Electronic Key into the proper connector
(see Fig. 6).
•
Press:
ENTER – ENTER – digit
Hotel Code
– ENTER – 3 –
digit
Area Master Code
– ENTER.
•
On the display it will appear a
Password
for 10 seconds. This
password has to be immediately taken down. Once copied the
Password, remove the Electronic Key and insert the plastic cap. This
way the Electronic Key could only open the safes of the hotel where it
has been set the Area Master Code inserted during this procedure of
association.
•
Register following details in the form “Electronic Keys attribution table”
(Appendix C): the serial number of the Electronic Key printed on the
key itself, the description of the access zone for which the key has
been associated, the name of the operator to which the key will be
given. It is recommended to get the signature of the operator, as
receipt confirmation.
Repeat same procedure for all the Electronic Keys
that will be given to the operators of the hotel.
Fig. 6
Maxi 4875 and Midi 4845
Installation and User Manual
Page 16 of 40
Associate (by means of a Password) the Electronic Key to an Area
Master Code previously set
A.3
Open the safe with Electronic Key and Password
To open the safe it is necessary:
•
Unthread the plastic cap situated near the display, on safe door top
right corner and insert the Electronic Key into the proper connector
(see Fig. 6 page 15).
•
Press:
ENTER
–
digit the
Password
(obtained with the
previously described procedure)
–
ENTER
. The safe will be
opened.
•
Remove the Electronic Key and insert the plastic cap.
Open the safe with Electronic Key and Password
After the opening with the Electronic Key, each time a key is pressed on the
display it will appear the word “MAStEr”, followed by “HELP”, meaning that
the safe has been opened without using the Guest Code. Furthermore,
for
security reasons, the Guest Code is automatically deleted (it is
necessary to set it up again).
ENTER
ENTER
Hotel Code
ENTER
3
ENTER
Area Master Code
ENTER
ENTER
Password
