Maxi 4875 and Midi 4845
Installation and User Manual
Page 27 of 40
4.9
Printing of the Audit Trail (optional printer)
Maxi 4875 and Midi 4845 safes have a connector for the connection to the
hand-held printer (optional), through which it is possible to print the Audit
Trail in order to read it more easily and to use it for evidence against third
persons (guests, hotel staff, etc..).
To print the Audit Trail it is necessary:
1.
Switch the printer on.
2.
On the safe, unthread the plastic cap situated near the display, on
safe door top right corner (see Fig. 6 page 15) and connect the
printer to the safe connector with the supplied cable.
3.
Enter the Service Code by pressing:
ENTER – COMB – digit
Service Code
- ENTER
4.
Press
2
to enter the “Print Audit Trail” function.
5.
The printer starts printing while the message “Print” starts blinking
on the display .
6.
After having printed the first 25 operations, the printer enters in
stand-by position and on display appears the word “PrintEd”; now:
press
ENTER
to stop printing, then switch the printer off;
or
press
any
key
to
another
25
operations.
Then repeat point 6.
Printing report starts from the last operation and is similar to the following
one:
DATE
HOUR
TYPE OF
OPERATION
(i.e. OPEn)
FURTHER INFO
(i.e. wrong code)
The list of the possible printed events with their relevant meanings is
reported in Appendix B.
Maxi 4875 and Midi 4845
Installation and User Manual
Page 28 of 40
4.10
Mechanical blocks during the safe closing / opening
(mechanical error warning)
Mechanical block during the safe closing
If the mechanical block during the safe closing prevents the deadbolts from
going out from the safe door for a time period of more than 10 seconds,
following events will occur:
•
the deadbolts withdraw into the safe door;
•
a sound signal indicates the error;
•
the message “ErrMEC” appears on the display for 3 seconds.
Now the safe is ready for a new operation.
Remove the obstacles preventing the deadbolts from moving regularly and
close the safe again.
Mechanical blocks during the safe opening
If a mechanical block occurs during the safe opening, the message “ErrMEC”
will appear on the display for 3 seconds.
In this case it is possible to open the safe with the mechanical emergency
key only. After the opening with the mechanical key, each time a key is
pressed on the display it appears the word “EMEr” (which indicates an
opening with the emergency key) and then “HELP” : it is therefore necessary
to insert a new Guest Code.
