It is important to keep the media and laminating fi lm under tension using the clutch
adjustments. If the tension is too tight, the roller system may be damaged; if the tension
is too loose, the media will not be laminated properly.
Pull the laminated media under the tension arm, then pass it between the aluminium
rollers. The guide can be adjusted to prevent the media from shifting.
Put the lever, located in the rear of the plotter, in the down position.
Pull the media through the plotter, keeping the media edge in contact with the alignment
points.
Set both pinch rollers at about 2mm from the media edge.
8
WHEN TO ADJUST THE CLUTCH
HOW TO LOAD THE LAMINATED MEDIA INTO THE PLOTTER
While holding the media in the aligned position with one hand, lift the handle on the rear
of the plotter with the other to secure the media.
Press button 2 as requested on plotter’s display.