15
ADVANCED OPTIONS
21
22
23
24
25
21.
Settings
22.
List of cut logs
23.
Set interface’s language
24.
Restore of the plotter’s settings
25.
Additional information
1.
Cutting file preview.
2.
Alignment adjustement controls.
3.
Status bar.
4.
Selects the cutting file.
5.
Open the last cutting file.
6.
Controls to move the media forward or backward.
7.
Camera preview .
8.
To set the distance between the base of each black-mark.
9.
To set the size of the black-marks.
10.
Enable or disable blank mode.
11.
To set the distance between each label.
Any extra border on the bottom of your cutting file is added to the step.
12.
To set the Graphtec’s blade strength and increase the cutting depth. Its value can be
from 1 to 31. The most common values in label cutting are from 7 to 9.
13.
To set the cutting speed. Its value can be from 50 to 600. The most common value in
label cutting is 600. If you have a cutting force major than 9, you may need to decrease
the cutting speed to have a proper precision.
14.
Flag to determined number of copies to cut during a cutting job launched with the
“Start” button, otherwise the plotter will continue and stop at the end of the media.
15.
Counts the number of copies cut since pressing the “Start” button.
16.
Section where to put the number of copies needed to be cut.
17.
Start/Cancel button. Used to launch or stop a cutting job.
18.
Pause/Resume button. Used to pause or resume the cutting job.
19.
Used to launch a single cut to let the user check the cutting parameters.
20.
Advanced controls.
move down
the cutting file
move to the right
the cutting file
move up
the cutting file
move to the left
the cutting file
-x
+y
+x
-y
cutting
direction