Settings (21)
1
2
3
4
5
6
7
8
9
10
11
12
1.
When you launch a cut with new offsets, they will be added to the deltas. The deltas
store the saved offsets.
2.
All the 100% magenta lines in your cutting file will be recognized as dashed. Here you
can set the cut length and the spacing between each on of them. They must be at least
0.1mm, and not more than 819mm.
3.
Here you can choose to enable or disable the media or lamination sensors. If “Media/
Lamination sensors” is checked, when the material ends, the software stops the cut and
will give you an alert.
4.
Approximation of the cut curves.
5.
If cut sorting is enabled, the software will automatically select the order of the cut of all
the shapes on the file. Otherwise, the cut will follow the .pdf layers order.
6.
When you print your rolls, sometimes you may have distortion on your output. In that
case, even with a correct set of the offsets, the cut may not match your print. You will have
to enable the distortion fixer, and set the corrections. A positive value will stretch the cut
on that axis, otherwise with a negative one, the cut will be more compressed.
16