>> How to run the blank mode
1. Press “OPEN PDF” or “OPEN LAST JOB” to load the cut file.
2. Set the copy mode
ON
, and set 2 as number of copies.
3. Click “START”.
4. Check the horizontal position and the gap between the cuts.
5. If necessary, adjust the offset X and the distance between each cut in the “STEP” box.
6. Once the cut is set properly, select copy mode: ON if you desire a preset quantity of
copies, or OFF to cut until the media roll is empty.
7. Click “START”.
10
WARNING:
Before starting a job, always remove the waste
media from the matrix remover core.
Tape the matrix securely onto the cardboard core.
System operating issues may occur if the above
suggestions are not followed.
HOW TO LOAD THE MATRIX REMOVER CORE HOLDER
1. Load empty cardboard core(s) and tighten the core holder, then place the motorized
core holder in position.
2. Peel back the matrix.
3. Pull the matrix and attach it to the matrix remover core holder.
4. Pull down the waste press and relocate the o-rings to be over the waste matrix.
5. Close the sponge roller