Chapter 2 Assembly and installation guidelines
Manual VIPA System 300V
2-8
HB130E - CP - RE_343-2AH10 - Rev. 08/41
In the following the cabling of the three variants of the front-facing
connector is shown:
For the I/O modules the following plugs are available at VIPA:
20pole screw connection
VIPA 392-1AJ00
40pole screw connection
VIPA 392-1AM00
Open the front flap of your I/O module.
Bring the front connector in cabling position.
For this you plug the front connector on the module until it locks. In this position the front
connector juts out of the module and has no contact yet.
De-isolate your wires. If needed, use core end cases.
Thread the included cable binder into the front
connector.
If you want to lead out your cables from the bottom of the module, start with the cabling from
bottom to top, res. from top to bottom, if the cables should be led out at the top.
Bolt also the connection screws of not cabled screw clamps.
Put the included cable binder around the cable
bundle and the front connector.
Fix the cable binder for the cable bundle.
continued ...
Front connectors
of the in-/output
modules
