VIPA CP 1413plus, Manual, Page: 88 / 328

3COM ISA-bus adapter CP1413plus manual
3-48 Rev. 00/07
3.2.4.1.4 MS-DOS Version D with IBM LAN Requester 4.0
Refer to chapter 3.2.3 for hardware installation instructions.
This installation includes the following components:
- H1 under MS-DOS
- IBM LAN Requester 4.0
Step 1
Please install the VIPA CP1413plus H1 network adapter as described in chapter 3.2.3.1.
Step 2
Set the required parameters, if necessary.
Step 3
Install the IBM LAN Requester according to the instructions supplied by IBM. Install
the "3Com Etherlink
®
III" network adapter to provide the ethernet interface.
Step 4
Please restart your PC. The network should start and run correctly.
To test the operation of the network you can send a message to another network client as
follows:
net send [name of recipient] ["message"]
Step 5
Please copy the H1 directory for the Windows Multiprotocol onto your hard disk.
xcopy A:\H1_DOS\VAR_D\*.* C:\H1_DOS\
Step 6
Add the lines contained in the file C:\H1_DOS\CONFIG.SYS to the C:\CONFIG.SYS file
LASTDRIVE=p
device=c:\net\protman.dos /I:c:\net
device=c:\net\ndishlp.sys
device=c:\h1_dos\elnk3.dos
device=c:\h1_dos\h1prot.dos
If the LASTDRIVE parameter exists, change it to read LASTDRIVE=P.