VIPA CP 1413plus, Manual, Page: 65 / 328

CP1413plus manual VIPA CP1413plus network adapter
Rev. 00/07 3-25
3.1.4.3 Windows NT installation
Installation procedure for expert users
A script file is available for the installation of the H1 drivers for Windows NT. This script file will
be processed as soon as the H1 driver is installed for the first time.
Please proceed as follows:
Step 1
Install the MAC-driver for the network adapter
Step 2
Insert the H1 driver disk into drive A: and select “other protocol” from the window. A
further selection panel will be displayed.
Step 3
Select "A:\H1_NT". The disk will be read and the selection panel will display "VIPA
H1-Protokoll". Please select this protocol.
Step 4
If you have installed a number of network adapters and some of these are not VIPA
CP1413plus adapters, you must remove the link between the H1 protocol driver and all
non-VIPA adapters. Otherwise the H1 driver will not operate properly.
Installing H1prot.sys for WindowsNT
Step 1
Please install the VIPA CP1413plus H1 network adapter as described in chapter 3.1.3.1.
Note you may have to change certain settings. We recommend that you set the
address to 340h if this is unused in your PC.
Step 2
Install the network adapter as follows:
- start the “Control Panel” in the “Main” group.
- select “Network” in the “Control Panel”.
- in "Network Settings" select "Add adapter".
- select the "DEC DC21040 PCI Ethernet Controller" from the list.
- The type of cable may be set to "Auto Detection".