VIPA CP 1413plus, Manual, Page: 304 / 328

Programming CP1413plus manual
7-98 Rev. 00/07
EthernetStation= aabbccddeeff
Ethernet address of the addressed station. Station addresses are always 6 Bytes in length.
You must specify 12 numbers. This entry is a HEX number
Example: EthernetStation=080006010001h
EthernetNSAP=
NSAP of the addressed station. NSAP is not implemented on Siemens H1 systems.
EthernetEigenerTSAP=
(EthernetOwnTSAP) Own TSAP. A TSAP can be from 2 to 16 characters in length. This
entry is a HEX number.
Example: EthernetEigenerTSAP=2020202030202031h
EthernetFremderTSAP=
(EthernetRemoteTSAP) Remote TSAP. A TSAP can be from 2 to 16 characters in length.
This entry is a HEX number.
Example: EthernetFremderTSAP=2020202030202031h
EthernetStartParameter=
Additional connection parameters. These parameters are used internally by the destination
system. The effect of the parameters depends on the destination system. This entry is a HEX
number. Example: EthernetStartParameter=20303436h
EthernetLeitungsart=
(Ethernet line type) Defines the type of operation. Accepted values are "Normal", "Normal,
Aktiv", "Normal, Passiv", "Broadcast", "Multicast" and "Datagramm". "Normal" on its own
means "Normal, Aktiv". Example: EthernetLeitungsart=Normal,Aktiv
EthernetPriority=
The priority of the connection. Industrial Ethernet (H1) accepts the following:
Prio0, Prio1 "Express" priority (up to 16 bytes of data)
Prio2, Prio3 normal priorities
Prio4 lowest priority.
Example: EthernetPriority=Prio2
EthernetMulticastkreis=
(EthernetMulticastCiruit) This contains the multicast circuit number for multicast
connections. For any other type of connection this parameter is ignored.
Example: EthernetMulticastkreis=2
The following parameters are provided for information purposes only, i.e. they have no influence on
the operation:
Auftragsnummer= (task number)
AuftragsKachelOffset= (task page frame offset)
Auftragsart= (task type)
VerbindungBenutzt= (connection in use)