Vinyl Express Qe60, User Manual

Page: 60 / 116

4 – 18
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key. The following menu is displayed.
Use the , , , and (POSITION) keys to move the cutter pen to the position for plotting of the
crosshairs, and then press the (ENTER) key. The crosshairs are plotted and the following is displayed.
Press the (ENTER)
key
. The sensor scans the crosshairs and overwrites them.
Measure the offset of the crosshairs in the X-axis, and enter the distance adjustment. Using the crosshairs
that were plotted first as the point of reference, enter the actual amount of the offset between these
crosshairs and the adjustment crosshairs that were plotted after the first crosshairs were read by the sen-
sor. (For example, for the figure shown above, since there is an offset in both the –X and –Y directions,
enter the [X= –**mm] and [Y= –**mm] corrective values.)
Use the or key to move the cursor to the digit to be entered, use the or key to increase or
decrease the values (or display/don’t display “-” for the space to the right of “=”), and then press the
(ENTER) key to confirm. If there is no offset, simply press the (ENTER) key. The Y-axis distance-
adjustment input is then displayed and should be set in the same way. To cancel the selection(s), press the
(NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
5
Step
6
Step
7
Step
8
Step
9
Step
10
Step
11
M A R K S E N S O R A D J 2
M A R K A D J 2 S C A N
P R E S S E N T E R K E Y
A D J X = 0 . 0