Vinyl Express Qe60, User Manual

Page: 20 / 116

2 – 6
Pull the leading edge out of the front of the cutting plotter so that it completely covers the media sensor. If
the leading edge has been pulled out too far, turn the roll to adjust the length of the medium that is protrud-
ing.
Adjust the position of the left- and right-hand push rollers to suit the width of the roll medium.
After ensuring that there is no slack in the medium’s conveyance path, raise the media set lever to lower
the push rollers and provide slack in the medium for a length corresponding to the length of the medium to
be used.
Raising the media set lever displays a menu for selection of the media mode. Select the media mode.
Step
3
Load the medium so that it passes over the media sensor.
Step
4
Step
5
Step
6
If the “REALIGN ROLLERS” message is displayed when the medium is loaded
and the media set lever is raised, either the right-hand push roller is not positioned
over the right-hand wide grit roller or the left-hand push roller is not positioned over
the grit roller. Check to confirm that they are positioned correctly.
Media sensor
CHECKPOINT
Raise media set lever to
clamp medium
Provide slack
R O L L 2 P R E S S E N T R
CHECKPOINT